Using Telnet - ATTO Technology FibreBridge 2370E Installation And Operation Manual
Atto fibrebridge operation manual
Hide thumbs
Also See for FibreBridge 2370E:
- Interoperability matrix (1 page) ,
- Specifications (2 pages) ,
- Installation and operation manual (51 pages)
Table of Contents
Advertisement
• Flow Control: None
• Terminal type: ASCII
• Echo: on
f. Click OK.
4
After you connect to the FibreBridge, start-up
messages are displayed. These messages are
only displayed at start-up. The last line in the
start-up message sequence is Ready .
5
In serial port sessions, there is no prompt on
the line below the word Ready . Begin typing
commands in the blank line where the cursor is
Using Telnet
Up to three Telnet sessions can be conducted
simultaneously. A serial port session can use the CLI
while Telnet sessions are open. Whichever session
issues the first set CLI command can continue to
issue set commands, while the other sessions can
only issue get commands or display information.
Once a connection is established, refer to
provides ASCII-based Interface
Appendix.
1
Connect to the FibreBridge from a computer on
the same Ethernet network.
2
Start a Telnet session.
CLI
on page ii of the
resting. No user name or password is required
for serial port access.
6
To verify that you have connected successfully,
type help after the Ready prompt and press
Enter.
• If a list of all available commands does not
appear on the screen, review the steps in this
section, check the cable, or contact service
personnel until the problem is solved.
If you have difficulty using the serial port, verify that
you have the correct settings and that your serial cable
is less then two meters in length.
Note
There is more than one way to connect to the
FibreBridge using a telnet program.Your telnet
program may operate differently than in the
following instructions.
3
At the telnet prompt, issue the open command
where x.x.x.x is the IP address of the
FibreBridge.
telnet > open x.x.x.x
4
If you have to specify a port type, enter the port
type "telnet" and the terminal type "vt100".
port type: telnet
terminal type: vt100
5
Enter the default values for the user name,
root , and the password , Password , if you did
not set new values in
23
.
Modify passwords on page
28
Advertisement
Table of Contents
