Multiple Node Addressing (Fb2400 Only) - ATTO Technology FibreBridge 2370E Installation And Operation Manual

Here, type in your user name and password,
and click OK .
1 The Status page appears.
2 From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.

Multiple Node addressing (FB2400 only)

The FibreBridge has a unique Port name for each
Fibre Channel port. By default, each Fibre Channel
port also has a separate unique Node name: the host
computer perceives the FibreBridge as two separate
entities, allowing mapping of a different set of logical
units to each FC port.
You may use a combination of the Command Line
Interface and ExpressNAV to change the default
setting to create a single Node name for the
FibreBridge and map devices to that node.
1 Connect to the FibreBridge using the
Command Line Interface as described in
Interface options on page 27.
3 The Mapping page appears. Wait for the
automatic scan for devices to complete.
4 Select the devices from the box on the right
hand side of the screen and drag to the
appropriate LUN on the left.
5 Click Submi t. All the commands necessary to
enable mapping and the command
saveconfiguration norestart are performed.
2 At the Ready prompt, type
set FCMultiNode disabled
Note
Changing the state of the FCMultiNode
command causes all maps to be deleted.
3 Press Enter .
4 Type saveconfiguration restart.
5 Press Enter.
6 Follow the directions in Mapping devices
automatically or Mapping devices manually.
above.
18