ATTO Technology FibreBridge 2370E Installation And Operation Manual page 47

VirtualRobotResponse
Provides proxy responses to SCSI INQUIRY commands if an
existing SCSI command is outstanding to a Media Changer. All
other SCSI commands are returned with a NOT READY check
condition.
Default: disabled
set VirtualRobotResponse [enabled | disabled]
Requires a SaveConfiguration restart command
get VirtualRobotResponse
Voltage (FB 2350, FB 2400)
Displays the voltage levels monitored by the FibreBridge.
VDDA: +3.31 V
VDDB: +2.49 V
VDDC: +1.5V
VDDD: +1.35V
ALL: all monitored voltages
get Voltage [VDDA | VDDB | VDDC | VDDD | all]
WrapEventLog
When enabled, the FibreBridge logs up to 2,048 event entries
before wrapping (overwriting the first entries). If disabled, the
FibreBridge stops logging event entries when the buffer is full.
Default: enabled
set WrapEventLog [enabled | disabled]
Requires a SaveConfiguration command
get WrapEventLog
WrapTraceLog
When enabled, the FibreBridge logs up to 2,048 trace entries
before wrapping (overwriting the first entries). If disabled, the
FibreBridge stops logging trace entries when the buffer is full.
Default: enabled
set WrapTraceLog [enabled | disabled]
get WrapTraceLog
zModem
Allows transfer of a firmware image to or from the FibreBridge
using the zModem file transfer protocol. Available only through
the RS232 interface.
zModem [Send filename | Receive]
CAUTION CAUTION
After a firmware image is downloaded to
the FibreBridge, the image is placed into
flash memory. During this time (about 30
seconds), DO NOT remove power to the
FibreBridge or the flash may become
corrupted.
xiv