Attach The Filter - Daikin MCK75JVM-K Service Manual

SiBE81-909
5.6

Attach the Filter

Attach the Filter
Attach the pleated Filter
Be sure to attach the pleated filter before
starting the unit.
1
Remove the front panel.
• Push the 2 projections (left and right) inwards, and
pull the front panel upwards and remove.
Front panel
2
Remove the water tank.
• Holding the water tank by the handle, pull the tank
upwards and out of the unit.
(1)
Pull
Water tank
3
Remove the UNIT1.
• Holding the UNIT1 by the handle, pull the UNIT1
upwards and out of the unit.
Handle
(1)
Pull
Humidifying Air Purifier
Projection
(1 each on left and right)
(2)
Up
(2)
Up
UNIT1
CAUTION
• Do the following before plugging in the
power supply cord.
4
Remove the deodorizing catalyst unit.
• Holding the deodorizing catalyst unit by the
handle, pull the deodorizing catalyst unit
upwards and out of the unit.
Handle
(1)
Pull
Deodorizing catalyst unit
Push
5
Attach the pleated filter.
Attach the pleated filter with the white side
facing to the front.
• Fit the projections (5 locations) on the left and
right faces of the deodorizing catalyst unit into
the holes (5 locations) on the left and right of
the pleated filter.
Face the white
side to the front
• Insert the pleated filter underneath the tabs (4
locations) at the top and bottom of the
deodorizing catalyst unit.
Top and bottom tabs (4 locations)
NOTE
• Always run the unit with both a pre-filter
(green) and pleated filter (front: white, back:
blue).
Running the unit without both filters may lead
to damage.
• Unit performance drops if the pleated filter is
attached backwards.
Operation Manual
(2)
Up
Projection
(5 each on left and right)
Pleated filter
Holes
(5 each on left and right)
Deodorizing catalyst unit
16
25