Daikin MCK75JVM-K Service Manual page 40

SiBE81-909
Pleated filter replacement
REPLACE HUM
RESET
(Push for 2 sec.) (Push for 2 sec.)
If the Air-purifying filter lamp lights or flashes
1
Remove the front panel.
2
Remove the water tank.
3
Removed the UNIT1.
• Holding the UNIT1 by the handle, pull the UNIT1
upwards and out of the unit.
Handle
(1)
Pull
4
Remove the deodorizing catalyst unit.
• Holding the deodorizing catalyst unit by the handle,
pull the deodorizing catalyst unit upwards and out of
the unit.
Handle
(1)
Pull
NOTE
• If the deodorizing catalyst unit is dirty, suck up dust with a vacuum cleaner. If the plate is dirty, wipe off dirt with
a piece of cloth or tissue moistened with water.
For stubborn dirt, wipe with a cloth moistened with a neutral liquid detergent. (Do not rinse in water.)
Humidifying Air Purifier
Cannot be rinsed in water
The pleated filter does not need
replacing until the Air-purifying filter
RESET
lamp lights or flashes.
Replace
Page 29.
Page 29.
(2)
Up
UNIT1
(2)
Up
Deodorizing catalyst unit
• Before performing maintenance, stop the unit and
unplug the power supply cord.
5
Replace the pleated filter with a new filter.
(1) Remove the used pleated filter.
• Release the pleated filter from the
projections (5 locations each) on the
left and right of the deodorizing
catalyst unit (front side).
(2) Take a new pleated filter from the filter
storage area, remove it from its bag and
attach it to the deodorizing catalyst unit.
Attach the pleated filter with the white
side facing to the front.
• Fit the projections (5 locations) on the
left and right faces of the deodorizing
catalyst unit into the holes (5 locations)
on the left and right of the pleated filter.
Face the white
side to the front
• Insert the pleated filter underneath the
tabs (4 locations) at the top and bottom
of the deodorizing catalyst unit.
Top and bottom
tabs (4 locations)
Page 28.
Operation Manual
CAUTION
Projection
(5 each on left and right)
Pleated filter
Holes
(5 each on left and right)
Deodorizing catalyst unit
30
39