Humidify And Air Purifying Operations - Daikin MCK75JVM-K Service Manual

SiBE81-909
5.9

Humidify and Air Purifying Operations

Humidify and Air Purifying Operations
• Do not move the unit while it is running. Displacements
may cause water leaks, damage or malfunctions.
1
Press ON/OFF
2
Press
HUM ON/OFF
• If humidification was run the last time that the unit was used, the humidification lamp lights
automatically.
3
Press
HUM SET
• Each time the button is pressed, the humidify
setting changes as follows.
LOW STD
4
Press
FAN SET
• Each time the button is pressed, the airflow rate changes as follows.
• The fan will be set to auto mode if the HIGH, STD, or LOW humidity setting is selected while in
humidifying operation. The airflow rate setting cannot be select.
• To set the airflow rate, set the humidify setting "CONT". Humidifying capacity increases
alongside airflow rate.
• When set to "auto", airflow rate is automatically adjusted according to the dirty state of the air
and humidity in the air.
ATTENTION
• As water is supplied from the water tank to the humidifying tray, the sound may be heard, but there
is nothing wrong with the unit.
• If the set humidity is reached or the water supply lamp lights during humidification, humidification
stops, but air purifying operation continues.
• Humidification rate varies according to the airflow rate setting.
Humidifying Air Purifier
Humidification lamp
.
to light the humidification lamp.
to change the humidify setting.
HIGH CONT
to change the airflow rate.
Air purifying operation is in active
while humidifying operation.
(Humidification cannot run by itself.)
NOTE
• Be sure to install the humidifying
filter to run the unit.
Operation Manual
20
29