Daikin MCK75JVM-K Service Manual page 42

SiBE81-909
UNIT1 (Plasma ionizer) removing and attaching
CAUTION
• Wear rubber gloves to remove and attach the opposing pole plates. Hands can be cut on the opposing pole plates and ionized wires.
Remove
1
Remove the front panel.
2
Remove the water tank.
3
Removed the UNIT1.
• Holding the UNIT1 by the handle, pull the UNIT1
upwards and out of the unit.
Handle
(1)
Pull
4
Remove the opposing pole plates on the
backside of UNIT1.
• Pinching together the white and green knobs (2 sets
on left and right), lift the opposing pole plates up
and out.
Wear rubber
gloves.
There are ionized wires
inside, therefore be careful
that they do not catch on
anything.
Ionized wire
Humidifying Air Purifier
Page 29.
Page 29.
(2)
Up
UNIT1
Opposing pole
plates
Pinching the sets of knobs
on the left and right at the
same time makes it easier to
remove the opposing pole
plates.
Knob Knob
Ionizing frame
(green) (white)
Attach
1
Attach the opposing pole plates.
(1) Fit the opposing pole plates over the
knobs (2 sets on left and right) on the
ionizing frame.
The opposing pole plates have no required
right and left direction and can be attached
either side of ionizing frame. Attach them
so that the arrow is visible.
Wear rubber
gloves.
Ionizing frame
(2) Insert securely until it clicks.
(3) Attach another side of the opposing pole
plate.
2
Restore the UNIT1
water tank and front panel.
Operation Manual
Arrow
Knob (white)
, pre-filter,
Page 31.
Page 29.
32
41