Attach The Filter - Daikin MCK75JVM-K Operation Manual

Attach the Filter

Attach the pleated fi lter
Be sure to attach the pleated fi lter
before starting the unit.
1
Remove the front panel.
• Push the 2 projections (left and right) inwards, and pull the
front panel upwards and remove.
Front panel
2
Remove the water tank.
• Holding the water tank by the handle, pull the tank
upwards and out of the unit.
(1)
Pull
Water tank
3
Remove the UNIT1.
• Holding the UNIT1 by the handle, pull the UNIT1 upwards
and out of the unit.
Handle
(1)
Pull
UNIT1
4
5
Push
Projection
(1 each on left and right)
(2)
Up
(2)
Up
CAUTION
• Do the following before plugging in the power supply cord.
Remove the deodorizing catalyst unit.
• Holding the deodorizing catalyst unit by the handle, pull
the deodorizing catalyst unit upwards and out of the unit.
Handle
(1)
Pull
Deodorizing catalyst unit
Attach the pleated fi lter.
Attach the pleated fi lter with the white side facing to
the front.
• Fit the projections (5 locations) on the left and right faces
of the deodorizing catalyst unit into the holes (5 locations)
on the left and right of the pleated fi lter.
Projection
(5 each on left and right)
Face the white
side to the front
• Insert the pleated fi lter underneath the tabs (4
the top and bottom of the deodorizing catalyst unit.
Top and bottom tabs (4 locations)
NOTE
● Always run the unit with both a pre-fi lter (green) and pleated
fi lter (front: white, back: blue).
Running the unit without both fi lters may lead to damage.
● Unit performance drops if the pleated fi lter is attached
backwards.
(2)
Up
Pleated filter
Holes
(5 each on left and right)
Deodorizing catalyst unit
locations) at
16