Loading Acc Keys; Figure 20. Acc Key Example - iDirect evolution x1 Installation Manual

Configuring TRANSEC ACC Keys
6.2

Loading ACC Keys

If the current ACC Keys and pass phrase are not available, coordinate with the Network
Operator to obtain them over a secure link. The procedure for retrieving the current ACC Keys
from the hub is documented in the iDX iBuilder User Guide, available on the TAC Web site.
Sample ACC Keys are shown in
To Load the ACC Keys:
1. Open a terminal session to the Satellite Router and log in to the root account. (See
"Connecting to the Console Port" on page 17
2. Enter the command:
telnet localhost
3. At the Username prompt, log in to the admin account.
4. At the command line prompt, enter the command:
csp enable
5. Enter the command:
keyroll_mgr setACCKey
6. A prompt appears for each of the three segments (lines) of the encrypted key and the
pass phrase. Respond to each prompt with the requested information. You can type
quit at any time.
7. When asked to continue, enter:
Yes
A message appears stating that the Network Acquisition Key has been updated.
After loading the ACC Keys, continue to
30
Figure 20.

Figure 20. ACC Key Example

for details.)
"Pointing the Antenna with iSite" on
iDirect Satellite Router Installation and Commissioning Guide
to
Q
page 31.
iDX Release 3.3