Setting Geographic Location Using The Console; Setting Geographic Location Of An X7 - iDirect evolution x1 Installation Manual

Setting Geographic Location using the Console

If commissioning an Evolution X7 Satellite Router, see
on page 76. For all other mobile remotes, site latitude and longitude coordinates are entered
via the console port using the
Note: If the Satellite Router is not configured as mobile on the iBuilder Remote Geo
Location tab, it is not possible to change the geographic location from the
console or from Web iSite.
13.2 Setting Geographic Location using the Console
To set the geographic location using the console:
1. Telnet to the Satellite Router or open a console session using the procedure
to the Console Port" on
2. Log in as root and telnet localhost to the admin account.
3. At the prompt, enter the following:
latlong
Where:
latitude
N or
longitude
E or
Note: Do not enter the <> marks.
CAUTION:
Double-check the geographic coordinates before pressing ENTER.

13.3 Setting Geographic Location of an X7

Enter the geographic coordinates for an Evolution X7 Satellite Router using Web iSite.
To set the geographic location of an X7:
1. Establish a connection to Web iSite using the procedure as described in
Web iSite" on
2. Log in to Web iSite.
3. Click the Commissioning button at the top of the Web page.
4. In the left-hand menu pane under Commissioning, click Geo Location to open the Geo
Location page
76
latlong
page 17.
<latitude> <N or S> <longitude>
is the current latitude in decimal notation
is either (for North) or
S N
is the current longitude in decimal notation
is either (for East) or W (for West) longitude
W E
page 41.
(Figure 45).
"Setting Geographic Location of an X7"
command as described in the following section.
<E
(for South) latitude
S
iDirect Satellite Router Installation and Commissioning Guide
"Connecting
or W>
"Connecting with
iDX Release 3.3