Figure 41. Web Isite: Antenna Peak Indication - iDirect evolution x1 Installation Manual

Peaking the Antenna
9. Move the antenna in azimuth so as to maximize the level of the green bar and the PWM
output voltage. See
10. If the downstream carrier signal is not found, increase or decrease the elevation setting
in 2° increments and repeat the azimuth sweep until the signal is found.
11. When locked on to the carrier:
a. Fine-adjust elevation for maximum.
b. Fine-adjust azimuth for maximum.
c. Lock the azimuth and elevation axes in place.
d. Fine-adjust the feed polarization angle for maximum.
12. Record the final antenna pointing voltage reading and report the reading to the Network
Operator.
13. On the Antenna Pointing screen, click Stop Tx PWM to exit the antenna pointing mode.
14. Remove power from the Satellite Router. The unit must be restarted to completely exit
the antenna pointing mode.
15. Disconnect the voltmeter from the Tx IFL. Do not re-connect the BUC at this time.
Note: The Satellite Router must be reset to fully exit pointing mode and re-enable the
operational state. Remove power from the Satellite Router before continuing.
64
Figure 41.

Figure 41. Web iSite: Antenna Peak Indication

iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3