After Securing The Antenna; Figure 48. Isite: Specify Modulated Carrier Dialog Box - iDirect evolution x1 Installation Manual

5. Wait for the access controller to make a measurement. The access controller may say to
continue moving the feed in the same direction, or to reverse direction. Continue as
directed until the required isolation is achieved.
6. Secure all fasteners and the hose clamp.
It may be necessary to re-peak azimuth and elevation in order to achieve sufficient cross-pol
isolation. The access controller may ask for fine adjustments in azimuth or elevation before
repeating the cross-pol adjustment. Follow the directions of the access controller. Securely
fasten all antenna axes after peaking and isolation have been optimized.

14.4 After Securing the Antenna

Wait for the access controller to verify that cross-pol isolation and peaking did not change due
to tightening of the antenna axis fixing hardware. Confirm that the Network Operator has
recorded the final cross-pol isolation value.
If directed to modulate the test carrier:
If using iSite:
1. Click the Start Modulated button
dialog box.
2. In the Specify Modulated Carrier dialog box
directed.
3. Click OK to modulate the carrier.
If using Web iSite:
a. In the Modulation field of the Modulator section, select BPSK
b. Enter the Symbol Rate as directed.
c. Click the Start button.
After completing the cross-pol isolation adjustments, proceed to
Maximum Power" on
iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3
(Figure

Figure 48. iSite: Specify Modulated Carrier Dialog Box

page 85.
After Securing the Antenna
46) to open the Specify Modulated Carrier
(Figure 48), enter the Symbol Rate as
"1 dB Compression Point and
(Figure 47).
83