Initial Acquisition; Figure 53. Imonitor Probe: Changing The Satellite Router Transmit Power - iDirect evolution x1 Installation Manual

Initial Acquisition

16.2 Initial Acquisition
Following establishment of the P1dB Compression point, the Satellite Router is powered on
and the receive IF cable is disconnected. Perform the following procedures under clear sky
conditions to acquire the network for the first time.
Note: In a TRANSEC network, the Network Operator must Disable Authentication for
the Satellite Router on the iBuilder Remote
hub-side configuration. See "Using the iDirect CA Foundry" in the iBuilder User
Guide.
To Prepare to Acquire the Network:
1. Remove power from the Satellite Router.
2. Reconnect the receive IF cable from the LNB to the RX In port.
3. Reconnect power to the Satellite Router.
4. Monitor the Satellite Router LEDs to observe progress and confirm that the Satellite
Router's receiver has locked to the outbound carrier. (See the LED tables in
LEDs" on
Depending on the initial power setting in the options file, the Satellite Router may or may not
join the network. In either case, the Network Operator should follow the steps below to bring
the Satellite Router into the network (if necessary) and to determine the clear sky operating
power of Satellite Router. During this procedure, the local installer should monitor the
Satellite Router acquisition status as the Network Operator adjusts power.
To Acquire the Network and Determine the Clear Sky Transmit Power:
1. Log in to iMonitor.
2. In the iMonitor Tree, expand the Inroute Group containing this Satellite Router.
3. Right-click the Satellite Router in the iMonitor Tree and select Probe from the menu.
4. In the Remote Power section of the Probe dialog box, click Change to open the Change
Remote Tx Power dialog box

Figure 53. iMonitor Probe: Changing the Satellite Router Transmit Power

92
page 94.)
(Figure

Information tab and apply the
53).
iDirect Satellite Router Installation and Commissioning Guide
"Front-Panel
iDX Release 3.3