Figure 51. Isite: Transmitting A Modulated Carrier; Figure 52. Web Isite: Transmitting A Modulated Carrier - iDirect evolution x1 Installation Manual

• Video BW: 1 kHz
• Averaging: 10 sweeps (This is required to smooth out in-band ripple)
3. Start the Transmit Power at the CW P1dB power level. (Refer to
4. Wait until the access controller is ready.
5. If using iSite:
a. Click Start Modulated in the Cross Polarization dialog box to open the Specify
Modulated Carrier dialog box.
b. In the Specify Modulated Carrier dialog box
Rate of 128 kilosymbols per second.
c. Click OK to transmit the modulated carrier.
6. If using Web iSite:
a. In the Modulation field of the Modulator section, select BPSK
b. Accept the default Symbol Rate of 128 kilosymbols per second.
c. Click Start to transmit the modulated carrier.
7. While the access controller observes the spectrum analyzer, increase power in 1 dB
increments.
8. After each 1 dB power increase, have the access controller clear the averaging mode set
in Step 2
iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3

Figure 51. iSite: Transmitting a Modulated Carrier

Figure 52. Web iSite: Transmitting a Modulated Carrier

and restart averaging.
Optional Procedure to Determine PN Max Power
(Figure 51), accept the default Symbol
Figure 50 on page 87.)
(Figure 52).
89