Evolution X7; Table 10. Idirect Evolution X7 Led Definitions - iDirect evolution x1 Installation Manual

16.3.4 Evolution X7

Table 10 contains LED definitions for the Evolution X7 Satellite Routers.
Label Color
POWER Off
Green
Yellow
STATUS Off
Flashing Green
Green
Red
FAN Green
Red
TEMP Off
Green
Yellow
Red
RX1/RX2 Off
Yellow
Flashing Yellow
Green
Red
TX Off
Yellow
Green
NET Off
Yellow
Flashing Yellow
Flashing Green (2 sec)
Flashing Green (1 sec)
Green
Note: LED indications and definitions are software-controlled, and may differ from
previous iDX releases. The definitions in this chapter apply to iDX Release 3.3.
iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3

Table 10. iDirect Evolution X7 LED Definitions

Definition
No power or low power input
Valid power input detected
Incorrect BUC voltage selection
Power off or executing initial self-test
Self-test failed
Normal operation
Fault: software, hardware, configuration, or self-test
All fans working
Failure of one or more fans
Satellite Router off, or initializing if STATUS is not green
Normal operating temperature
Operating temperature near high or low threshold
Operating temperature exceeds high or low threshold
Receiver off or not configured. (RX2 not supported in iDX 3.3)
Demodulator not locked to the downstream carrier
Demodulator locked. NCR not locked.
Demodulator locked. NCR locked.
Operating temperature exceeds high or low threshold
Transmitter off. If STATUS is green, transmitter configured off.
Transmitter enabled and muted
Transmitter enabled and not muted
Satellite Router off or in sleep mode if TX is yellow
Demodulator not locked to the downstream carrier
Demodulator locked. NCR not locked.
Demodulator locked. NCR locked.
Network acquisition in progress
The Satellite Router is in the network
Front-Panel LEDs
97