Table of Contents
Advertisement
3.2.07 Edge Guide Assemblies and Paper Load Shaft
1. Remove the preliminary items.
2. Remove the front cover.
3. Remove the rear cover.
4. Remove the carrier frame assembly.
5. Remove the manual insert tray.
6. Remove the pick roll hub, shaft, and envelope bucklers.
7. Remove the two screws (1) from the right side frame (2).
8. Work the paper load shaft (3) out of the side frames.
9. Pull up the bottom of both the left (4) and right (5) edge guides to separate them from the top of the
back plate and remove the assembly from the frames.
NOTE:
Installation
Be sure that the left (6) and right (7) edge guide springs are turned to the INSIDE to maintain
spring tension on the guides.
P/N 51018001 Assembly: Left Edge Guide
P/N 51018201 Guide: Right Edge & Width Strip RSPL
P/N N/A
Gear: Paper Load (Gears B/M)
P/N 58237001 Packet: Accessory Parts
Chapter 3 Maintenance and Disassembly
. . . . . . . . .
(3.2.01
. . . . . . . . . . . . . . . (3.2.12
. . . . . . . . . . . . . . .
(3.2.30
. . .
(3.2.04
(3.2.20
. . . . . .
RSPL
RSPL
Service Guide OJ2010
)
)
)
)
)
. . .(3.2.25
)
B.2.08
B.2.08
B.2.08
B.2.08
Page: 64
Advertisement
Table of Contents
