Table of Contents
Advertisement
3.4.04 Areas to be Cleaned
Printer Parts
Areas to be Cleaned
Carrier Guide Rod
Contacts inside the print cartridge carrier
Covers
Paper Paths
Print Nozzles
Ink Spills
Before discarding a used print cartridge, place it a leak-proof bag to contain any remaining ink.
Service Guide OJ2010
Chapter 3 Maintenance and Disassembly
Action to be Taken
Wipe with a clean soft lint-free cloth
dampened with water. Wipe dry.
1. Refer to the Nozzle Test
Cleaning the Carrier Contacts in this
section of the Service Handbook
Use a clean dry cloth to clean the contacts
inside the cartridge carrier in the printer. This
procedure is also covered in the User's Guide
and may be performed by the end user.
Clean with soft cloth and all-purpose cleaner
Wipe up paper bits and dust.
1. Run the Nozzle Test
the nozzles.
2. Refer to the Nozzle Test
Wiping the Nozzles and Contacts in this
section of the Service Handbook.
Use a clean cloth dampened with water only
to gently clean the entire copper colored area
of the print cartridge including the nozzles and
contacts.
When cleaning the color print cartridge wipe
the nozzles in
ONLY
colors
DO NOT
mix.
DO NOT
touch the copper-colored area with
your fingers!
To dissolve dried ink hold the damp cloth
against the nozzles for about three seconds.
Gently blot and wipe dry.
Allow the copper-colored area to dry before
installing the cartridge.
This procedure is also covered in the User's
Guide and may be performed by the end user.
.
.
to clean (purge)
.
one direction so the
Page: 97
Advertisement
Table of Contents
