Table of Contents
Advertisement
Page: 130
Service Guide OJ2010
Chapter 4 Failure and Repair Analysis
RAP 02: First Print Line Service Check
1. Check the End of Forms Flag for binds or damage.
2. Check the End of Forms Sensor for dirt.
3. Perform the End of Forms Sensor Test.
Refer to Section 4.8 of this Service Handbook
.
This checks the operation of the end of forms sensor on the sensor board.
4. Check all parts of the feed arm assembly for binds, wear, or damage.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Advertisement
Table of Contents
