Table of Contents
Advertisement
3. Remove the printhead carrier assembly.
4. Separate the cradle (1) from the printhead carrier assembly (2) by pushing out the cradle latches (3).
5. Remove the rubber backer (4) and paper deflector (5) from under the printhead carrier cable (6).
NOTE:
Installation
Use the diagram to assemble the carrier parts in the correct sequence.
Be sure that the cable is secured under the three retaining clips (7) on the back of the carrier.
P/N 51711201
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
. . (3.2.28
Rubber Backer: Printhead
)
RSPL B.2.06
Advertisement
Table of Contents
