Table of Contents
Advertisement
4. Gently pry the code module (EPROM) from the system board.
NOTES:
Note the position of the notch in the module.
The notch is down.
Removing the system board resets the head to head and bi-directional printing alignments to factory
defaults. The end user performs these alignments through the User Software Utility. Refer to the Users
Guide for details.
When replacing the system board, be sure to remove the EPROM at U56. Replacement boards are
shipped WITHOUT the EPROM.
Check Okilink II for information updates on the EPROM.
CAUTION:
When removing the EPROM, you must follow standard electrostatic sensitive device (ESD) procedures or
you may damage the components.
P/N N/A EPROM B.2.05
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Advertisement
Table of Contents
