Table of Contents
Advertisement
Page: 123
Service Guide OJ2010
Chapter 4 Failure and Repair Analysis
4.5 ABNORMAL OUTPUT
4.5.01 Output Samples
Light Or Blurred Output
In the printer setup dialog box:
Click the Media / Quality tab, then
change the Print Quality setting to something other than Draft.
and / or turn the Ink Saver setting off.
Click the Image Settings tab, then make a Brightness and Contrast adjustment.
Make sure that you are using the correct type of paper.
Check the print cartridges.
Make sure that the cartridges are installed correctly.
Refer to Section 3.4 of this Service Handbook, Print the Nozzle Test
.
Clean the nozzles.
Check the ink level. Click on the Cartridges tab in the Printer Control Dialog box.
Smudged Or Dark Output
In the Printer Setup Dialog box, click the Media / Quality tab, then change the Ink Saver setting to Medium
Advertisement
Table of Contents
