Table of Contents
Advertisement
4.6 FAULT ALARMS
4.6.01 General Information
The printer can be serviced without being connected to a host computer.
When an error condition exists, the Power
determined by counting the number of flashes.
Refer to the Flashing Power
recommended corrective action for each condition.
Flashing Power Light Error Indicator Table
Service Error Indications
Service Error Indications are displayed as a series of flashes of the Power
There is a pause between each series of flashes.
If a Service Error Indication is displayed, refer to the table shown below.
Locate the Service Error Indication and take the corrective action.
After taking the corrective action, unplug the unit to clear the error indicator.
Flashing Power ON Light Error Indicator Table
Number
Error Code
of Power
Light Flashes
1
81
4
89
6
66 - 78
7
64, 65
8
83
Chapter 4 Failure and Repair Analysis
ON
light will flash. The type of error condition can be
ON
Error Indicators in this section to identify both the error condition and the
Action
Perform RAP 09 Transport Service Check.
Section 4.7 of this Service Handbook
Perform RAP 09 Transport Service Check.
Section 4.7 of this Service Handbook
Replace the Code Module and / or the system board.
Replace the Code Module and / or the system board.
Replace the Code Module and / or the system board.
Service Guide OJ2010
ON
Page: 124
light.
Refer to
.
Refer to
.
Advertisement
Table of Contents
