Table of Contents
Advertisement
NOTE: Note that the printhead cable is routed under the retaining clip on the carrier.
4. Disconnect the printhead cable (1) from the encoder card (2).
5. Separate the cradle (3) from the printhead carrier assembly (4) by pushing out the cradle latches (5).
6. Feed the folded end of the printhead cable through the opening in the carrier assembly and remove
the cable.
NOTE:
Installation
Use the diagram to assemble the carrier parts in the correct sequence.
Be sure that the cable is secured under the three retaining clips (6) on the back of the carrier.
P/N 56632001 Cable: Printhead (With Folds)
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
RSPL B.2.06
Advertisement
Table of Contents
