Table of Contents
Advertisement
Shipping Restraint Removal
The printer shipping restraints must be removed prior to operation. The following tools are
required to remove the shipping restraints from a pedestal model:
D
3/32" inch hex wrench
D
3/8" nut driver
D
diagonal cutters
Do not connect the ac power source before removing the shipping restraints. If the
power has been connected, disconnect it prior to performing the shipping restraint
removal procedures to prevent possible injury. In addition, the shipping restraints
must be installed whenever the printer or shuttle assembly is shipped or trans
ported to prevent damage.
The printer contains 2 platen restraint screws and a foam rubber pad inserted behind the trac
tor sprockets. Each screw is tagged with a red WARNING label. After mounting the printer on
the pedestal or table top, perform the following procedure and refer to Figure 10-14 to re
move the shipping restraints. A 3/8" nut driver and a 3/32" hex wrench are required.
1.
Raise the printer cover.
2.
Rotate the Vertical Position Knob (A) clockwise and pull the rubber pad down and out.
3.
Cut and remove the tie wrap securing the Forms Thickness Adjustment Lever (B) on the
left side of the printer.
4.
Notice the red WARNING label on the restraint screw (C) on the left side of the printer.
Using a 3/8" nut driver or wrench, remove the restraint screw from the left side.
5.
Notice the red WARNING label on the right side restraint screw (D). Using a 3/32" hex
wrench, remove the restraint screw from the right side.
6.
Cut and remove the nylon string binding the power cord at the rear of the printer.
Installation
WARNING
-
-
10-15
Advertisement
Table of Contents
