Table of Contents
Advertisement
Pedestal Model Installation
The following section on Pedestal Model Installation provides information pedestal assembly,
table top mounting, and shipping restraints removal for the P6000L Series printers.
Pedestal Assembly
To assemble the optional pedestal for pedestal model printers, perform the following instruc
tions. A 5/16" nut driver and 5/32" hex wrench are required.
1.
Verify the pedestal shipping kit contains the following items:
2 pedestal legs
n
12 machine screws
n
1 modesty panel
n
4 flat washers
n
2.
As shown in Figure 10-10, position the back side of the modesty panel (A) against the
pedestal legs (B) facing the long end of the leg base. With the 5/16" nut driver, secure the
panel to the legs with 4 machine screws (C) on each side of the back of the panel.
3.
Place the printer on a sturdy table with 2 of the printer's rubber feet (D) hanging over the
edge of the table as shown in Figure 10-11. Using the 5/32-inch hex wrench, remove the
2 exposed rubber feet. Rotate the printer to expose the remaining 2 rubber feet and re
move them.
4.
As shown in Figure 10-12, carefully place the printer on the pedestal facing the front.
Align the printer's rubber feet holes (E) with the pedestal mounting holes (F). Install two
screws with washers through the pedestal mounting holes on each side to secure the
printer to the pedestal.
5.
If equipped with the optional paper stacker, refer to the Paper Stacker Information and
Assembly Instructions.
Installation
10-11
Advertisement
Table of Contents
