Table of Contents
Advertisement
Introduction
Configuration refers to a set of operating parameters that define how the printer will respond
to commands sent from the host computer. Most all the configuration parameters are selected
from the control panel as shown on the Control Panel Switch Function Diagrams. A few con
figuration parameters are hardware selectable by jumpers on the Logic C board as described in
the Hardware Jumper Configuration section.
Before reconfiguring any printer function, be sure to read this entire chapter. The following
information is presented:
Lock/Unlock Printer Configuration
n
Configuration Menus
n
Configuration Procedure
n
Set/Save/Load Configuration Values
n
Default Configuration Values
n
Configuration Printout
n
Hardware Jumper Configuration
n
Control Panel Switch Function Diagram
n
Locking/Unlocking Printer Configuration
As previously described in the Operation chapter, the printer configuration is locked to pre
vent accidental or unintentional reconfiguration. Pressing the RUN/STOP TEST and CON
FIG MENU switches simultaneously will alternately unlock or lock the printer configuration.
The Printer configuration must be unlocked to reconfigure the printer from the control panel.
NOTE: While DATA IN BUFFER is present, the printer configuration will remain
locked. Press PAPER ADVANCE, TOP-OF-FORM, or ONLINE to empty the print
er's buffers and remove the DATA IN BUFFER condition.
Configuration Menus
The CONFIG MENU switch accesses and displays the various control panel selectable con
figuration menus. The individual parameter values within each menu are displayed by repeat
edly pressing the CONFIG VALUE switch. The following configuration menus appear on the
message display:
Ribbon Life
D
Configuration
CHAPTER 3
CONFIGURATION
3-1
Advertisement
Table of Contents
