Printronix P6000L User's Reference Manual page 199

Removing the Side Shock Mount Restraint Screws - After removing the side panel and lower
ing the card cage, the remaining four shock mount restraint screws can be accessed and re
moved. Perform the following instructions and refer to Figure 10-9.
1. Remove the left two restraint screws (A) located above the fan housing (B) with the 3/8"
nut driver.
NOTE: A universal joint nut driver may be required to access the screws.
2. Remove the right two restraint screws (C) located to the right of the fan housing (B) with
the 3/8" nut driver.
3. After removing the last restraint screw, return the card cage to the full upright position
and tighten the wing nut.
4. Replace the side panel. Make sure the mounting studs and side panel release screw are
properly seated.
5. Tighten the side panel release screw.
6. Reconnect the ground wire connectors.
7. Lower the printer cover.
Installation 10-9