Table of Contents
Advertisement
Mounting Hardware
To install the CVX 600 chassis in a rack, you need a Phillips #2 screwdriver and a
computer rack that meets the specifications listed in
page
If the rack does not have threaded rail holes, you must use cagenuts and cagenut
screws (not supplied).
296-1011-202 Rel. 5.0, Doc. Rev. 02.01
Note: Before you turn on the CVX 600, you should connect a local
terminal or PC to the CVX 600 console port. This console will display
diagnostic information. If there is a startup problem, in which case, you
need to contact Nortel Networks Technical Support (see
Services"
on
page
xviii).
1-7.
Preparing for the CVX 600 Installation
"Rack Requirements"
Chassis Installation
"Customer
on
1-17
Advertisement
Table of Contents
