Replacing Modules And Filler Panels; Introduction; Removing And Installing Filler Panels - Nortel CVX 600 Hardware Installation Manual

CVX 600 Hardware Installation Guide

Replacing Modules and Filler Panels

Replacing Modules and Filler Panels

Introduction

This section provides instructions for replacing chassis components and hardware
modules. It describes how to:
• Remove and install filler panels
• Replace the SCC-SM
• Replace the SCC-LTM or SCC-RLTM
• Replace other service modules (SMs)
• Replace DAC-LTMs and DAC-RLTMs

Removing and Installing Filler Panels

You must install filler panels in any empty slots at the front or rear of the
CVX 600 chassis. Filler panels ensure proper air circulation in the chassis, as well
as assist in emissions compliance. If you need to install a card in an empty slot,
you must first remove the filler panel.
3-4
Note: You must wear an antistatic wrist strap when you remove or install
these components and modules.
296-1011-202 Rel. 5.0, Doc. Rev. 02.01