Replacing A Contivity 4600 Power Supply - Nortel Contivity 4600 Installing

50 Chapter 4 Changing the Hardware Configurations
7
Pull up the locking levers on both sides of the next available DIMM, and snap
the DIMM into its socket.
8
Replace the support bracket by tightening the two secured captive screws and
the rear Phillips screw.
9
Push in the slide-out tray and tighten the thumb-screws.

Replacing a Contivity 4600 power supply

To remove the power supply:
1
Remove the front bezel as shown in
2
Use a flat-head screwdriver to unscrew the top and bottom power supply
screws, as shown in
311641-A Rev 00
Figure
Figure 14.
9.