Nt6D80 Multi-Purpose Serial Data Link Card - Nortel Circuit Card 311 Reference

92 Option settings
NT6D68 Core module backplane
Table 28
NT6D68 Core module backplane
Jumper (between slots)
Note: Berg jumpers are located along the bottom of the primary side of the backplane. (This
is inside the card cage assembly.)
JB4
JB3
JB2
JB1

NT6D80 Multi-purpose Serial Data Link card

Table 29
NT6D80 Multi-purpose Serial Data Link card
RS-232-D DTE or DCE*
RS-422-A DTE (terminal)
RS-422-A DCE (modem)
RS-232-D DTE or DCE*
RS-422-A DTE
RS-422-A DCE
RS-232-D DTE or DCE*
RS-422-A DTE
RS-422-A DCE
RS-232-D DTE or DCE*
RS-422-A DTE
RS-422-A DCE
* RS-232-D DTE and DCE modes are software configured. RS-422-A DTE and DEC modes are
switch configured.
Note: The device number for the MSDL card is configured in LD17 at the prompt DNUM. You must
also set the device number, using switches S9 and S10, on the MSDL card. S9 designates ones
and S10 designates tens. To set the device number as 14, for example, set S10 to 1 and S9 to 4.
Copyright © 2003-2008, Nortel Networks
.
Location
9 / 10 Jumper plug not installed
10 / 11
11 / 12
12 / 13
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Core 1
Plug installed
Plug installed
Plug installed
Port 0—SW4
all off
all off
all on
Port 1—SW3
all off
all off
all on
Port 2—SW2
all off
all off
all on
Port 3—SW1
all off
all off
all on
Core 0
Plug installed
Plug installed
Plug installed
Plug installed
Port 0—SW8
all off
all on
all off
Port 1—SW7
all off
all on
all off
Port 2—SW6
all off
all on
all off
Port 3—SW5
all off
all on
all off