Nortel Circuit Card 311 Reference page 528

528 NT8D02 and NTDK16 Digital Line cards
Jumper and switch settings
The NT8D02 Digital Line card has no user-configurable jumpers or switches.
The card derives its address from its position in the backplane and reports
that information back to the Call Server through the LAN Link interface.
The NT8D02 Digital Line Card has no user-configurable jumpers or
switches. The card derives its address from its position in the backplane
and reports that information back to the Meridian 1 CP through the LAN
Link interface.
The NT8D02 Digital Line Card has no user-configurable jumpers or
switches. The card derives its address from its position in the backplane
and reports that information back to the Meridian 1 Call Processor through
the LAN Link interface.
The NT8D02GA, NT8D02HA, and NT8D02HAE5 Cards are based on a
different architecture and hence need a jumper (J1) to activate/deactivate
the unterminated line detection feature. When connected to digital sets, the
jumper J1 should be removed. This enables the unterminated line detection
feature. This jumper settings is applicable only to NT8D02GA , NT8D02HA,
and NT8D02HAE5 packs.
Software service changes
Voice and data ports are configured using LD 11. See Software Input/Output
Reference — Administration (NN43001-611) for LD 11 service change
instructions. Voice and data ports are configured using the Meridian Digital
TelephoneAdministration program LD 11. See the Software Input/Output
Reference — Administration (NN43001-611) for LD 11 service change
instructions.
Copyright © 2003-2008, Nortel Networks
.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008