Physical Description - Nortel Circuit Card 311 Reference

•
•
•
The Universal Trunk Card also supports Music, Automatic Wake Up, and
Direct Inward System Access (DISA).
Table 232 "Supported trunk type and signaling matrix" (page 571)
of the trunk types and signaling supported by the Universal Trunk Card.
Table 232
Supported trunk type and signaling matrix
Loop start
Ground start
Loop dial
repeating
Loop OAID

Physical description

The trunk and common multiplexing circuitry is mounted on a 31.75 cm by
25.40 cm (12.5 in. by 10 in.) printed circuit board.
The NT8D14 Universal Trunk card connects to the backplane through a
160-pin connector shroud. The backplane is cabled to the I/O panel, which
is cabled to the Main Distribution Frame (MDF) by 25-pair cables. External
equipment, such as recorded announcement machines, paging equipment,
and Central Office facilities, connect to the card at the MDF. Each unit on the
card connects to the backplane through an 80-pin connector, the backplane
is cabled to the Input/Output (I/O) panel, and the I/O panel is cabled to
the cross-connect terminal. At the cross-connect terminal, each unit
connects to external apparatus, such as Central Office facilities or recorded
announcement equipment. Each unit connects to external apparatus by tip
and ring leads which carry voice, ringing, tone signaling, and battery.
See the Communication Server 1000M and Meridian 1 Large System
Installation and Configuration (NN43021-310) for termination and
cross-connect information.
Copyright © 2003-2008, Nortel Networks
.
Tie Two-way Dial Repeating (DR) and Two-way Outgoing Automatic
Incoming Dial (OAID)
Paging (PAG)
Note: All-call zone paging is not supported.
Recorded Announcement (RAN).
CO/FX DID/
WATS DOD
yes no
yes no
no yes
no no
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Physical description 571
Tie PAG
no no
no no
yes no
yes no
is a matrix
RAN
no
no
no
no