Nortel Circuit Card 311 Reference page 20

20 Overview
Figure 1
IPE line cards shown installed in an NT8D37 IPE module
When installing line cards, follow these general procedures:
Step
1
2
3
4
5
6
Copyright © 2003-2008, Nortel Networks
.
Action
Configure the jumpers and switches on the line card (if any) to meet
system needs.
Install the line card into the selected slot.
Install the cable that connects the backplane connector on the IPE
module to the module I/O panel.
Connect a 25-pair cable from the module I/O panel connector to the
Main Distribution Frame (MDF).
Connect the line card output to the selected terminal equipment
at the MDF.
Configure the individual line interface unit using the Analog
(500/2500-type) Telephone Administration program LD 10 for analog
line interface units and Multi-line Telephone Administration program
LD 11 for digital line interface units.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
—End—