Switching On The Power Supply; Turning The Power On - MIMAKI GP-1810 Operation Manual

Switching on the power supply

Turning the power on

1. Turn on the power to the computer which is
connected to the machine.
2. Turn on the power to the machine.
Press the power switch to " I ".
• Make sure that the station cover is closed.
If it is open, initialization is not performed.
• Leave 10 seconds and more intervals before
turning on the power after once turning off.
When the power is switched on, the LCD first displays
"BOOT" and then displays the firmware version number.
3. The message [Please Wait] appears flushing
on the LCD.
The initial operation of the machine is performed.
• To avoid injuries, keep your hands away
from the machine while in motion.
4. The machine enters the LOCAL mode.
Display the print area.
• The Local mode is not available until ink initialization is completed. Install the
ink cartridges. (Refer to page 24 of the setup guide.)
• The following message will appear when the ink cartridges are not installed:
Ink Cartridge
1 2 3 4 5 6 7 8 A B C D E F G H
- 2.3 -
BOOT
GP-1810 V∗.∗∗
Please Wait
<< LOCAL >>
X =1010 Y = 1860