Switching On The Power Supply; Turning The Power On - MIMAKI JV22-130 Operation Manual

Switching on the power supply

Power switch

Turning the power on

1. Turn on the power to the device.
Tilt the power switch toward the " I "side.
• Make sure that the front cover is closed.
If it is open, initialization is not performed.
When the power is switched on, the LCD first displays
"BOOT" and then displays the firmware version number.
2. The message "PLEASE WAIT" appears flash-
ing on the LCD.
The initial operation of the device is performed.
3. The device enters the LOCAL mode.
If a medium has been set on the device, the prompt Media
Select is displayed on the LCD.
4. Turn on the power to the computer which is
connected to the device.
: Located on the front face of the device.
BOOT
PLEASE WAIT
< LOCAL >
MEDIA SELECT
ROLL <
- 2.3 -
V X.XX
> LEAF