Table of Contents
Advertisement
How to shake the ink cartridge
To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels. Then,
shake it more than twenty times right and left so that ink flows inside the cartridge.
• If you shake it too strong, the pack inside may be damaged and it may cause ink leakage.
Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt the
cartridge until it becomes vertical.
A part
(the place to stick a
needle)
• If you shake the ink cartridge too strong, it may damage the inside pack and it may cause
ink leakage. Be careful about it.
• When the cartridge is new, shake it before taking it out of bag.
• When the cartridge is in-use, be sure to wear the gloves, press waste close to the inserted
side and shake it.
• If the remaining amount of ink is less, tilt it until it becomes vertical, as you cannot shake it
enough in some cases.
• When you use MBIS, do not shake the eco case and the intermediate cartridge.
• Do not insert and pull out the intermediate cartridge as much as possible. It may cause ink
leakage.
Set the interval to display the warning message
Depending on the ambient temperature, set the interval to display the warning preventing color material settling.
1
Select [ROUTINE SETUP] of the maintenance menu.
(1) Press the
(2) Press
(3) Press
(4) Press the
2
Press the
WARNING].
4-32
B part
(the slot on the
bottom)
Cover with paper towel firmly and shake ink slowly
key in LOCAL.
to select [MAINTENANCE] and press the
to select [ROUTINE SETUP].
key.
key to select [Sub-INK
Repeat
this
key.
ROU T I N E S E T U P
S u b - I N K WA R N I NG < e n t >
A part
Advertisement
Table of Contents
