Multifunction Switch - Can-Am DS 250 Operator's Manual

vmo2006-014-024_b
TRANSMISSION LEVER PATTERN
1. Forward (F)
2. Neutral (N)
3. Reverse (R)
To change the transmission lever po-
sition, completely stop vehicle, apply
brakes, then move lever to the desired
position. Do not force lever.
NOTE: Any shifting attempt at high
RPM or without brakes applied will
stop engine.
R: Reverse
This allows the vehicle to go backward.
This vehicle is equipped with a reverse
speed limiter system. Refer to
RIDE BUTTON
for more informations.
WARNING
Before operating the vehicle in re-
verse, ensure the path behind is
clear of obstacles or bystanders.
BRP recommends that you remain
seated. Avoid standing up. Your
weight could shift forward against
the throttle lever causing an un-
expected acceleration and loss of
control.
N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
F: Forward
It is the normal driving range. It al-
lows the vehicle to reach its maximum
speed.

6) Multifunction Switch

The multifunction switch is located on
the LH side of the handlebar.
The controls located on the multifunc-
tion switch are:
vmo2011-001-002_a
TYPICAL — MULTIFUNCTION SWITCH
1. Headlights switch
OVER-
2. Emergency engine stop switch
3. Engine start button
4. Override button
5. Choke lever
Headlights Switch
This is a 3 position switch that controls
the taillight and headlights simultane-
ously however, it has no effect on the
brake light.
_______________
CONTROLS/INSTRUMENTS/EQUIPMENT
63