Multifunction Switch - Can-Am Outlander X mr Series Operator's Manual

CONTROLS/INSTRUMENTS/EQUIPMENT
NOTICE
This gearbox is not de-
signed to shift while vehicle is mov-
ing.
P: Park
The park position locks the gearbox to
help prevent vehicle movement.
WARNING
Always use the PARK (P) position
when the vehicle is not in oper-
ation. The vehicle can roll if the
shift lever is not set to P (PARK).
R: Reverse
The reverse position allows the vehicle
to go backwards.
NOTE: In reverse operation, the en-
gine's RPM is limited, thus limiting the
vehicle reverse speed.
WARNING
When driving downhill in reverse,
gravity can increase the vehicle
speed above the set limited re-
verse speed.
Neutral
The neutral position disengages the
gearbox.
WARNING
Always use the PARK (P) position
when the vehicle is not in oper-
ation. The vehicle can roll if the
shift lever is set to N (NEUTRAL).
High Range (Forward)
This position selects the high speed
range of the gearbox. It is the normal
driving speed range. It allows the vehi-
cle to reach its maximum speed.
______________
76
Low Range (Forward)
This position selects the low speed
range of the gearbox. It allows the ve-
hicle to move slowly with maximum
torque at the wheels.
NOTICE
Use the low speed range
to pull a trailer, carry heavy cargo,
go over obstacles or drive uphill and
downhill.

6) Multifunction Switch

The multifunction switch is located on
the LH side of the handlebar.
The controls located on this multifunc-
tion switch are:
vmo2016-022-030_a
TYPICAL — MULTIFUNCTION SWITCH
1. Headlight switch
2. Emergency engine stop switch
3. Engine start button
4. Override/DPS button (if applicable)