Transmission Lever; Multifunction Switch - Can-Am DS 250 Operator's Manual

CONTROLS/INSTRUMENTS/EQUIPMENT
Brake lever should return to rest po-
sition. Always release parking brake
before riding.

5) Transmission Lever

A 3 position transmission lever is lo-
cated on the RH side of the vehicle
near the steering column.
NOTICE
Always completely stop
the vehicle and apply the brake prior
to moving the transmission lever.
vmo2006-014-024_b
TRANSMISSION LEVER PATTERN
1. Forward (F)
2. Neutral (N)
3. Reverse (R)
To change the transmission lever po-
sition, completely stop vehicle, apply
brakes, then move lever to the desired
position. Do not force lever.
NOTE: Any shifting attempt at high
RPM or without brakes applied will
stop engine.
R: Reverse
This allows the vehicle to go back-
wards. This vehicle is equipped with
a reverse speed limiter system. Refer
OVERRIDE BUTTON
to
mations.
______________
64
for more infor-
WARNING
Before operating the vehicle in re-
verse, ensure the path behind is
clear of obstacles or bystanders.
BRP recommends that you remain
seated. Avoid standing up. Your
weight could shift forward against
the throttle lever causing an un-
expected acceleration and loss of
control.
N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
F: Forward
It is the normal driving range. It al-
lows the vehicle to reach its maximum
speed.

6) Multifunction Switch

The multifunction switch is located on
the LH side of the handlebar.
The controls located on the multifunc-
tion switch are:
vmo2011-001-002_a
TYPICAL — MULTIFUNCTION SWITCH
1. Headlights switch
2. Emergency engine stop switch
3. Engine start button
4. Override button
5. Choke lever