Multifunction Switch - Can-Am DS 90 Operator's Manual

CONTROLS/INSTRUMENTS/EQUIPMENT
vmo2008-008-018_a
TRANSMISSION LEVER PATTERN
1. Transmission lever
2. Forward (F)
3. Neutral (N)
4. Reverse (R)
To change the transmission position,
completely stop vehicle, apply brakes
then move lever to the desired position
while moving lever forward or back-
ward. Do not force lever.
WARNING
Before moving vehicle in reverse,
ensure the path behind is clear of
obstacles or bystanders. Remain
seated.
F: Forward
It is the normal driving range. It al-
lows the vehicle to reach its maximum
speed.
N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
While reading this Operator's Guide, reminder that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
______________
58
R: Reverse
This allows the vehicle to go backward.

7) Multifunction Switch

The multifunction switch is located on
the LH side of the handlebar.
The controls located on this multifunc-
tion switch are:
vmo2009-004-005_a
1. Engine stop switch
2. Engine start button
3. Choke lever
Engine Stop Switch
This switch can be used to stop the en-
gine and as an emergency control.
NOTE: While engine can be stopped
by turning ignition key to OFF position,
we recommend the engine be stopped
by the engine stop switch.
WARNING