Can-Am DS 250 Operator's Manual page 121

VEHICLE CANNOT REACH FULL SPEED (cont'd)
2. Parking brake.
– Ensure brake lever lock is completely disengaged.
3. Air filter/housing clogged or dirty.
– Check air filter and clean if necessary.
– Check deposits in air filter housing drain.
– Check the position of the air intake tube.
4. CVT dirty or worn, including belt.
– Contact an authorized Can-Am dealer.
TRANSMISSION LEVER IS HARD TO MOVE
1. Transmission gears are in a position that prevents the transmission lever
engagement in a different selection.
– Rock the vehicle back and forth to move the gears in the transmission and al-
low the transmission lever to be set.
2. Engine idle speed is set too high.
– Adjust the idle speed. Refer to the TECHNICAL SPECIFICATIONS.
3. CVT dirty or worn.
– Contact an authorized Can-Am dealer.
THE RPM INCREASES BUT THE VEHICLE DOES NOT MOVE
1. The transmission is in NEUTRAL position.
– Set transmission in REVERSE or FORWARD.
2. CVT is defective.
– Contact an authorized Can-Am dealer.
3. Water in the CVT housing.
– Refer to CVT TRANSMISSION in MAINTENANCE INFORMATION.
______________
TROUBLESHOOTING GUIDELINES
119