Spark Plug - Can-Am DS 250 Operator's Manual

MAINTENANCE PROCEDURES
NOTE: If correct
unattainable,
Can-Am dealer.
The normal throttle
1 mm to 3 mm (.039 in to .118 in).
NOTE: Measure throttle free play at
the tip of throttle lever.
To adjust cable, slide rubber protector
back to expose throttle cable adjuster.
Loosen lock nut, then turn the adjuster
to obtain correct throttle lever free play.
Tighten lock nut and reinstall protector.
vmo2006-014-052_a
THROTTLE LEVER FREE PLAY ADJUSTMENT
1. Throttle lever
2. Protector
3. Cable adjuster
A. 1 mm to 3 mm (.039 in to .118 in)
With the transmission lever set to
NEUTRAL position, start the engine.
Check if the throttle cable is adjusted
correctly by turning handlebar fully to
the right then fully to the left. If the
engine RPM increases, readjust the
throttle lever free play.
Ensure throttle cable is properly routed
and not binding on anything when the
handlebar is turned.
______________
96
adjustment
see an authorized
free-play

Spark Plug

is
Spark Plug Removal
is
CAUTION Always wear safety
goggles when using pressurized air.
Disconnect spark plug cable from
spark plug.
Unscrew spark plug one turn.
Clean spark plug and cylinder head
with pressurized air if possible.
Unscrew spark plug completely and re-
move it from the engine.
vmo2006-014-066_a
LH SIDE OF ENGINE
1. Spark plug
Spark Plug Installation
Prior to installation, make sure the con-
tact surface of the cylinder head and
spark plug is free of grime.
Using a feeler gauge, set the spark plug
gap to 0.8 mm (.031 in).
Apply anti-seize lubricant over spark
plug threads to prevent a possible
seizure.
Screw spark plug into cylinder head by
hand and tighten with a torque wrench
and a proper socket.