Brake Pedal; Tool Kit - Can-Am DS 250 Operator's Manual

vmo2006-014-013_a
1. Align the pointer toward the desired position
2. RES. (reserve)
3. OFF
4. ON
OFF
Stops fuel supply to carburetor.
NOTICE
Turn valve to OFF position
when vehicle is not being operated
or when transporting.
ON
Allows fuel to flow to carburetor. This
is the normal position for operation of
the vehicle.
RES (RESERVE)
When the normal supply of fuel in the
tank is used up (ON position), an emer-
gency supply of fuel is available by
turning the valve to RES. The reserve
contains approximately 10% of the
fuel tank capacity. Use the RES posi-
tion only when the ON supply is empty.
When in reserve, refuel as soon as pos-
sible. be sure to turn the valve back to
the ON position after refuelling.
NOTICE
Improper opening of fuel
valve will restrict the flow of fuel.
Make sure valve is fully opened
while running.
CONTROLS/INSTRUMENTS/EQUIPMENT

10) Brake Pedal

The brake pedal is located on the RH
side of the vehicle near the engine.
When pressed, the rear brake is ap-
plied. When released, it should return
to its original position. Braking effect
is proportional to the force applied on
the pedal.
vmo2006-014-014_a
1. Rear brake pedal

11) Tool Kit

The tool kit is located in the service
compartment underneath the seat, it
contains tools for basic maintenance.
vmr2006-078-001_e
SERVICE COMPARTMENT UNDERNEATH
SEAT
1. Tool kit
_______________
67