Multifunction Switch; Controls/Instruments/Equipment (Cont'd) - Can-Am DS 250 Operator's Manual

To change the transmission position,
completely stop vehicle, apply brakes
then move lever to the desired position
while moving lever forward or back-
ward. Do not force lever.
NOTE: Any shifting attempt at high
RPM or without brakes applied will
stop engine.
R: Reverse
This allows the vehicle to go backward.
This vehicle is equipped with a reverse
speed limiter system. Refer to
RIDE BUTTON
further, for more infor-
mations.
WARNING
Before moving vehicle in reverse,
ensure the path behind is clear of
obstacles or bystanders. Remain
seated.
N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment or towing.
F: Forward
It is the normal driving range. It al-
lows the vehicle to reach its maximum
speed.

6) Multifunction Switch

The controls located on this multifunc-
tion switch are:
vmo2006-013-001_a
TYPICAL — MULTIFUNCTION SWITCH
1. Headlights switch
2. Engine stop switch
3. Engine start button
4. Override button
5. Choke lever
OVER-
Headlights Switch
vmo2006-014-055_a
TYPICAL — HEADLIGHTS SWITCH
FUNCTIONS
1. Headlights switch
2. Low beam and taillight
3. High beam and taillight
4. OFF position
Engine Stop Switch
This switch can be used to stop engine
and as an emergency control.
To stop engine, fully release throttle
lever then use the engine stop switch.
NOTE: While engine can be stopped
by turning ignition key to OFF position,
we recommend the engine be stopped
by the engine stop switch.
_____________________
CONTROLS/INSTRUMENTS/EQUIPMENT
61