Wireless; Wireless Settings - TP-Link TL-WR810N User Manual

IP Address - Enter the IP address of your system in dotted-decimal notation (factory default -

192.168.0.254).
Subnet Mask - An address code that determines the size of the network. Normally

255.255.255.0 is used as the subnet mask.
Gateway - The gateway should be in the same subnet as your IP address.

 Allow remote access - Allow remote devices to access the AP device by inputting the IP
address in browser.

Note:
1. If you change the IP address, you must use the new IP address to login the system.
2. If you select the type of Smart IP(DHCP), the DHCP server in this device will not startup.
3. If the new IP address you set is not in the same subnet, the IP Address pool in the DHCP
server will not take effect, until they are re-configured.
4. This device will reboot automatically after you click the Save button.
Click the Save button to save your settings.

Note:
When you choose the Smart IP (DHCP) mode, the DHCP Server function will be disabled.

5.7 Wireless

Figure 5-9 Wireless menu
There are six submenus under the Wireless menu (shown in Figure 5-9): Wireless Settings,
Wireless Security, Wireless MAC Filtering, Wireless Advanced, Wireless Statistics and
Throughput Monitor. Click any of them, and you will be able to configure the corresponding
function.

5.7.1 Wireless Settings

Choose menu "Wireless → Wireless Settings", and then you can configure the basic settings
for the wireless network on this page.
TL-WR810N 300Mbps Wireless N Mini Router
- 109 -