TP-Link TL-WR810N User Manual page 56

Time-based Connecting - The connection will only be established in the period from the

start time to the end time (both are in HH:MM format).

Note:
Only when you have configured the system time on "System Tools → Time" page, will the
Time-based Connecting function can take effect.
Connect Manually

connect/disconnect immediately. This mode also supports the Max Idle Time function as
Connect on Demand mode. The Internet connection can be disconnected automatically
after a specified inactivity period and re-established when you attempt to access the
Internet again.
Click the Connect button to connect immediately. Click the Disconnect button to disconnect
immediately.
Caution: Sometimes the connection cannot be terminated although you specify a time to
Max Idle Time because some applications are visiting the Internet continually in the
background.
If you want to do some advanced configurations, please click the Advanced button, and the
page shown in Figure 4-11 will then appear:
MTU Size - The default MTU size is "1480" bytes, which is usually fine. It is not

recommended that you change the default MTU Size unless required by your ISP.
 Service Name/AC Name - The service name and AC (Access Concentrator) name
should not be configured unless you are sure it is necessary for your ISP. In most cases,
leaving these fields blank will work.
TL-WR810N
- You can
WAN -
Figure 4-11 PPPoE Advanced Settings
- 40 -
300Mbps Wireless N Mini Router
click the Connect/Disconnect button to