Installing A Network Adapter Driver - Allied Telesis AT-2450 Series Installation Manual

Microsoft DOS Client 3.0

Installing a Network Adapter Driver

38
This section contains the procedure for installing a network adapter
driver on a Microsoft DOS Client 3.0 system.
Note
Before starting with the installation procedure, make sure that the
adapter is properly configured using setup25.EXE provided on the
CardAssistant CD. If necessary, match the speed and duplex settings
of the network card with the hub with which it is connected.
To install the network adapter driver, perform the following procedure:
1. Shut down Microsoft DOS Client 3.0 and power OFF the computer.
2. Install the network adapter card in the compute. Refer to the
Network Adapter Card Installation Guide - Book I and to your
computer's installation manual.
3. Power ON the computer.
4. Start the setup utility provided by Microsoft to install and configure
DOS Client v3.0.
5. At the Welcome screen, press Enter.
6. Choose the destination directory for the client files and press
Return.
7. When prompted for the network adapter, choose Network adapter
not shown on list below . . .
A prompt is displayed asking you to insert the OEM driver disk.
8. Insert the CardAssistant CD or the driver installation disk into the
appropriate drive.
9. Type in the driver letter and path to the NDIS 2.0 driver and press
Return.
If you are using the CD, the location of the adapter driver will differ
depending on the type of adapter. Below are the driver locations on
the CardAssistant CD:
Adapter Card
AT-2400 Series
AT-2500/AT-2501 Series
Driver Location
\drivers\at2400\msclient
\drivers\at2500\msclient