Failure Of A Test - Allied Telesis AT-2450 Series Installation Manual

Diagnostics

Failure of a Test

30
Figure 7 Diagonstic Window (2 of 5)
For a test to be completed successfully, each of the following conditions
must be met:
The network adapter operates correctly.
The network adapter is cabled correctly for the test or is equipped
with the correct connectors.
The network adapter has been installed correctly in the computer.
The failed message does not necessarily imply that the network adapter
is faulty.
If a failed message is displayed, perform the following procedure:
1. Follow the instructions that are displayed in the window below the
list of tests.
2. Make sure that the adapter is inserted correctly and the ports are
connected properly (connectors are firmly seated, the correct end of
the cable is connected).