Bootrom Parameter - Allied Telesis AT-2450 Series Installation Manual

The AT-2500 and AT-2501 adapter cards will require the card to be
configured for Boot ROM support, it is disabled by default. To enable
Boot ROM support, start the AT-2500 or AT-2501 DOS diagnostics
program, setup25 and enable the Boot ROM from the configuration
menu.
BootROM
1. Run the diagnostics program that came with your Allied Telesyn
adapter. (diag.exe, diag25.exe, etc.).
Parameter
2. If using an AT-2450 and AT-2700 series Combo card, set the
BootROM Parameter to the desired port (copper or fiber). If using an
AT-2500 series adapter set the BootROM parameter to enable.
For the AT-2450FTX, AT-2700FTX, and AT-2745FX versions with switches
you must set your switch to the proper position based on which port you
are using (Copper or Fiber).
Diag Setting
Copper
Fiber
1. Factory default.
Diag Setting
Fiber
Copper
1. Factory default.
Diag Setting
100 Mb
10 Mb
1. Factory default.
Note
For proper operation when BootROM is NOT installed insure the
Diagnostics parameter BootRom and switch are set to Factory
Default.
Table 1 AT-2450FTX
Switch Position
1 1
Up
Down
Table 2 AT-2700FTX
Switch Position
1
Down
Up
Table 3 AT-2745FX
Switch Position
1 1
Up
Down
Network Adapter Card Installation Guide - Book II
1
73